Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have an Cisco CUBE with two SIP Trunks, one for an NEC PABX and another for an Siemens PABX.
[NEC Phone] - [NEC PABX] - sip trunk - [CUBE] - sip trunk - [Alcatel PABX] - [Alcatel Phone]
When I start an call from an phone of NEC PABX I saw on...
Hi,
Does anybody know if has some configuration that unable the call to show the ID (not the call ID, is the number before the colon) on show call active voice brief on a voice gateway?
Telephony call-legs: 0SIP call-legs: 2H323 call-legs: 0Call a...
Hi,Someone has a working config of CME using SIP Phone 3905 and with pickup working?My issue is that pickup doesn't work.When I press the feature button then pickup I get reorder tone.I have configured pickup-group on voice register dn and the servic...
Someone know if I can have two calls on a Cisco SIP Phone 3905 on CME 8.8?And how can I (I didn't find on user or admin guide):1. answer a second call2. toggle between callsRgds,Fabio
Hi Mohammed!
The direct negotiation between the PABX didn't work before! CUBE is the solution that we believe that can be the middle element to enable this interwork.
One thing that is too strange is that I have two m lines with the same content (p...
Hi Ilana!
No, I didn't find how to enable Feature Access Code for SIP Phones, on the Cisco Unified Communications Manager Express System Administrator Guide says only for SCCP devices.
Regards,
Fabio Funaki
I'm running on this issue, but with an 7821, I opened a TAC case to check why it happens.As a workaround I configured another time zone that can show the correct time and I will proceed with TAC to try to identify why this happen. Regards,
