Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone had instability issues (packet loss, auto-negotiation) with Starlink ethernet handoffs? I ran a packet capture and I can see a lot of TCP retrans. When I plug the Starlink handoff to a Catalyst IOS or laptop it works fine.
I have a session that will not come up:Dec 18 07:46:33: %BGP-3-NOTIFICATION: received from neighbor <REMOTE PEER> active 2/5 (authentication failure) 0 bytes Dec 18 15:46:33.615: BGP: ses global <REMOTE PEER> (0x7FB1CD209CF0:0) act Receive NOTIFICATI...
I have 2 sites. HQ and Colo. I want to deploy BGP at both sites and announce the same IPV4 space and AS number at both sites. Behind the BGP routers I want to put one ASA at each site and run them as active/standby. I have a layer 2 connection betwee...
I have a SVI running PIM. With 1 sender and 1 receiver on a single muticast group over a the same VLAN, I get no data loss. As soon as I add another receiver (igmp join), I experience data loss and output drops on the all of the receivers ports.
I found that this may occur when the ACLs defining interesting traffic are one-sided.
Make sure that the ACL mirror each other especially when building IPSEC tunnels between an ASA and an IOS based device.
I have a 2900 with over 15 DMVPN tunnles and have the same issue. I have recently upgraded from 15.2.4.M1 to 15.3.2.T based on advice fro the TAC and that has not solved the issue. I also replaced the ISM and it crashed twice in a 2 hour stretch. If...
