Hi all I have a setup on customer site where CUCM and Ericson MD110 connect to each other via H323 Trunk. Everything working perfectly fine, except that when there is a call from outside or within a CUCM system and I try to transfer the call to the phone in ericson system, the CLID shown on ericson system is the phone that make a transfer call, not the original caller. I am quite sure that it realted to the configuration but I couldn't find any option on CUCM to fix this issue. regards, Pichan Pratummal ... View more

Hello Everyone, I have an anooy problem with ATA 187 on CME 9.0 I preconfigure everything back in the office, at that time ATA 187 work fine with CME - "show voice register pool type ata-187" show that both number were registered to CME. But for some reason after the device was send to the customer site, it always register with first port(second port show unregister). I try every solution I could think of, restart and reset the "voice register pool", delete and reconfigure dn and pool, no create profile and create profile, ect.. But None of the solution above work. Here is my configuration. voice register dn 98 number 5598 voice register dn 99 number 5599 voice register pool 1 id mac xxxx.xxxx.xxxx codec g711ulaw number 1 dn 98 number 2 dn 99 ... View more