Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have three DCs that I am preparing a configuration for. The plan is to use ISR4000-series routers and interlink the three sites with OTV. Initially was planning on using the Unicast-OTV mode. Staging a simplex setup, with no redundancy yet. Mapped...
We have a client that has a number of the 1552-series access points purchased in 2012 in a mesh setup. We need (for various reasons) to move some of those access points from UNII3 to UNII1 channels. In the past they were not available. Controller is ...
Hi!Can anybody comment on Cisco supported wifi bridges? Ie I have a device that doesn't have wireless card and needs to get on wireless network using its built in LAN card and a media bridge of some sort.Thank you.Sent from Cisco Technical Support iP...
Does anybody have a link to a list of differences between 3702e and 3702p? Looks like 3702p is suggested for dense deployment but what does that actually mean?
Guys, Do you know if there is a need to enable RTS/CTS mechanism for Cisco Mesh links (backhaul) or is there a protection embedded in the protocol itself somehow? Ie in the challenging terrains where hidden mesh nodes can affect communication is ther...
George,
Do you know if the multicast messaging are forwarded to the anchor controller in the recent firmware or is it still an unsupported feature?
Thank you.
If all your APs are in the hallways and cover offices to located on the sides then APs can see each other and will lower trasmit power (as they have direct LOS to each other). This may create an issue with the signal strength in the offices themselve...
Scott, The antenna gain will not be affected by the amplification of the signal (or so is in theory). Even antenna patterns are not related to mW in any way shape or form. Antenna pattern diagram shows you the main axe where the power is strongest an...
