Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We just upgraded to 2960S, POE, 1Gb ports. The 6941 phones (100mb port speed) work fine by themselves, but when you plug a computer into the back of the phone the speed is awful. I can plug the same computer directly into the switch and have no spe...
Has anyone had any luck with a route filter querying a NPA-XXX database for prefixes in a local calling area? I have a good query pointed at localcallingguide.com, but I am looking for a way to update the router filter automatically.Thanks,TJ
I just upgraded to Unity Connection 8.6 (HA). I am using the SIP integration to CUCM 8.5.1. The sip phones I am using are working great with MWI. None of the sccp phones are being notifiied with MWI. Does anyone know of any issues with this? MWI...
I have CCM 7.0.2 currently and am working on getting calls to display properly in the missed calls section of the IP Phones. I have an integration through a H.323 gateway to an Avaya PBX using PRIs. The Avaya and the Cisco CM are setup to dial 4 di...
Here is the interface status......GigabitEthernet1/0/14 is up, line protocol is up (connected) Hardware is Gigabit Ethernet, address is 04da.d24a.868e (bia 04da.d24a.868e) MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec, reliability 255/255,...
I just upgraded to the newest firmware (cmterm-69xx-sccp.9-3-3-2-sr1) on the phone. No change in the speed. The setup was previously on an Avaya (100mb port) and plugged into a 100MB Cisco 2950 Switch and the user was able to pull up the file immed...
I found the solution. I had to change the system policy on the UCM for "visual message waiting indicator policy" to "light and prompt. Once I applied that to the phones and re-synched the MWIs in Unity Connection.
I saw this same problem. I had extensions 2000-2500 setup to auto register new phones. After the first part of the large deployment, I started to see this problem. I checked the dbreplication and that turned out good. It turned out that all of th...
I got it figured out. Thanks for helping me point in the right direction. I added a translation rule on the VOIP dial peers pointed at the call manager. Here is what I added......voice translation-rule 1 rule 1 /212232\([2-8]...\)/ /\1/rule 2 /232...
