Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have VRF name TEST tied with Tunnel interface and this Tunnel using for DMVPN .
I used OSPF in same VRF as route protocol
I add one commands under OSPF 1 VRF TEST
The command was ”redestrubution eigrp 123 subnet” To test something. After few ...
I tried to contact Cisco DNA to internet in order to but my Cisco CCO on it and to make the update the application on it.
Which port should be using for that? And from where config that? It is from DNA itself ?
I try to put the prox by name and up...
Recently we deployed Cisco DNA in the network, using Port 2 DNA GUI as manage everything.
The question is How to config Port 1 10G?
From IMC through MGMT port or from KVM through magle ?
Do we need IP address on it? If Yes! What is the gateway...
Hi ,
I have QOS in my Switch ports and working good base to my LAN VLAN, But when I using wireless My traffic will be goes to Wireless VLAN. in Wireless VLAN there is no QOS. the question Do I need to put QOS config in the Wireless VLAN Interface ?
I using OSPF With VRF , And the issue router ver as below .
R01#sh version
Cisco IOS XE Software, Version 03.16.06.S - Extended Support Release
Cisco IOS Software, ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.5(3)S6, RELEASE SOFT...
I still have Networks running in this VRF OSPF Domain when the the OSPF goes shutdown .Yes there is ospf config under Tunnel interface, as I mentioned the router is DMVPN Hub .