Hi,We have 2 locations (using 6500's in hybrid mode) in our WAN that are connected our main bulding (using a 3550-12G) via fiber from Comcast. Both connections run over seperate VLANS on Comcast's network to their switches on sites. Our interfaces on...
I have a request for a light mounted on the outside of an office to indicate when the person is on the phone. We are currently running UCM 5.1.1 and using a 7960 phone.Any ideas? Thanks,Bob
Hi,We are going to be moving our subscribers from our existing 4.0(5) server to a fresh 5.0(1)install. Is there a way I can move the subscriber names and greetings and make it seemless to the subscribers? I have the password already.Thanks,Bob
I have a machine in the DMZ of our PIX 515E (6.3.3) that needs to connect to an outside IP address. It has Cisco VPN Client 4.0.4D and it is set up to allow transparent Tunneling and to use IPSEC over UDP (NAT/PAT). If I give it a public IP and stic...
I work for a school District and we have run into a few situations when we have received a bomb threat from a "Unknown Caller" Our administration wants to find out if there is a way to block calls with no Caller ID or possibly redirect them to a spec...
Giuseppe, Thanks for the response. VLAN 499 was set as the native vlan for the connection. earlier we had found that the Comcast link was set to 1500 bytes, but it should have been 1504 because they run it across a vlan on their network and hand it o...
I would like to do an in place upgrade on the old server first, but it falls way short of the hardware requirments for 5.0(1). We have over 600 users, so I was hoping to find a way to avoid going to each profile. I will pull off the important ones an...
Hi Rob,You are preaching to the choir. I also believe every bomb threat should be treated seriously and investigated.The blocking of calls without caller ID was asked by the administration (which I discouraged, but I told them I would check it out).I...
