About scottcummins

scottcummins · 04-03-2020

The final part of the procedure is to run "switch# copy running-config startup-config" however, my switch stays at "switch(boot)" and will not allow me to do a "copy running-config startup-config" how can I get to just the "switch"" prompt without do...

scottcummins · 04-01-2020

Good Day I have 4 MDS 9148 Fiber Channel Switches I want to re-use for a development network. They are older of course, But we just need a system where I can connect a VNX 5500 to a few Servers. I have searched the internet and I have found the "proc...

scottcummins · 03-11-2020

One of the most frustrating things I have ever tried to use. So I have repaced my networking backbone with a pair of NEXUS 9504s (N9K-X9464PX Blades) with 4 NEXUS 2348TQ-E FEX devices. I have the two ethernet (Broadcom NetExtreme) ports from the Del...

scottcummins · 03-10-2020

Good Day Cisco CommunityI have a Dell PowerEdge R420 Server with 2 Broadcom NetExtreme ethernet adapters both 1GB. The server is loaded with Windows 2008 R2 ServerI am trying to team the adapters using the Broadcom Advanced Control Suite software usi...

scottcummins · 09-16-2019

Good Day Cisco Gurus I currently have two 2500 series Controllers that re set up as an HA pair, I have two wireless networks configured. Guest: the guest is currently configured to allow access to the domain resources, I inherited these controllers a...

scottcummins · 04-09-2020

SerguiI appreciate very much all your help and replying to my questions. Thank you so much Scott

scottcummins · 04-08-2020

Sergui I wanted to ask, I was able to use the procedure on two spare MDS 9148s I have and got the password changed, I have two that are in production and have configs on them I don't want to lose.If I perform the exact same procedure, will it save my...

scottcummins · 04-06-2020

Sergui/anyone Thank you for that and I think I had booted to the wrong .bin. There are two of them/m9100-s3ek9-kickstart-mz-6.2.1.bin/m9100-s3ek9-mz-6.2.1.bin I booted to the "kickstart" one first Can you tell me what the difference is?

scottcummins · 04-02-2020

KirkIt will NOT let me perform a copy running-config startup-config. it is still at switch(boot)# and will not go to just switch#. How do I get to that switch root?

scottcummins · 04-02-2020

Kirk Thanks Believe it or not I tried that several times and could not get in. After you sent me this I tried it again and it worked. I feel pretty dumb. Now I have another question I may need to start a new thread. I am trying to run the Cisco Devi...

Member Since	‎10-16-2008 03:42 PM
Date Last Visited	‎07-20-2022 12:01 AM
Posts	125
Total Helpful Votes Received	10

User Statistics

User Activity

After Password recover on an MDS 9148.

Password Recovery for MDS-9148 MutliLayer Fabric Switch

Teaming NICS using BACS 4 on A Windows 2008 R2 Server

Creating a Port-Channel on New N9K system

2500 seriesWireless Controller configuration

Re: After Password recover on an MDS 9148.

Re: After Password recover on an MDS 9148.

Re: After Password recover on an MDS 9148.

Re: Password Recovery for MDS-9148 MutliLayer Fabric Switch

Re: Password Recovery for MDS-9148 MutliLayer Fabric Switch