Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am having Security License (SL-39-SEC-K9) for Cisco 3900 Series router, Can somebody help me to provide sample config to configure 3945 router to act as firewall. Is there any difference with the native IOS based firewall config..Regards,Mu...
Hi Team,Base on the network presented in the exhibit, Assuming that all routers have been configured to run eigrp in AS 100, and have also been configured to run eigrp on all connected links. if the link between R3 and R4 fails,how many queries will ...
Hi Team,when we were trying to upload the IOs image(18 mb) in cisco 7206 router in its disk2: file system through TFTP server (cross cable connected to the pc). after copying the IOS image till 18% i.e.almost 4 mb was copied and gives the error...%Er...
Hi,what will be the basic configuration is required in the router to make router as it is directly connected through console once will telnet the router with some port number.can anyboy suggest the config???Regards...Mukesh
Hi can anybody help the below mentioned error. Actually I was doing ios upgradation in cisco 2950 switch. and before that I ahve delete the existing ios image from the switch and once new ios image uploaded then I reloaded, but after that switch is s...
Hi Pankaj,As per your scenario, During congestion if class 2 traffic exceeds 40% bandwidth and then it may move to any other class which is not fully utilized and if defualt class is not congested, it may move to default-class. There could be situati...
Andrew,thanks for replying, now my question is..for which netwrk 10.10.1.0 or 10.10.2.0 both (R5 and R6)RTR will recve one query each. and as per my understanding as v r filtering out 10.10.1.0 n/w on R4, R5 shold recv one quesry for 10.10.2.0 frm R4...
Hi buddy,we can configure this thing in very simple way. configure the serial interface and for isdn configure BRI interface or creat the dialer and bind the dialer inside the serial interface as a backup line. give delay command. all traffic will go...
Yes Arindam you are right and Rick is also saying the same. pls try to resolve with the service provider might be they have opened data conncetion only one way.
