Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Wondered if anyone saw any issues with this or knows if it is or is not supported.Plan on a 2921 with 1 HWIC-4SHDSL as the CO end.I'd like to use 4 1-pair groups to connect to 4 respective CPE 888's.Thanks
Has anyone else hit this issue:006125: Nov 7 12:30:21.132 PST: %DNSSERVER-3-UDPDNSOVERLOAD: Low available memory: dropping <id# 37428> from <cli 192.168..x.x>.Using a UC520.Issue seen in following IOS:uc500-advipservicesk9-mz.151-4.M5uc500-advipserv...
I have have 2 UC series boxes connected via SIP dial-peers. Read as simple site-to-site peers.Box 1 has an FXO port connected to the PSTN.If a call comes in from box 2 via the SIP dial-peer, with digits matching the destination-pattern of the POTS ...
I have have 2 UC series boxes connected via SIP dial-peers. Read as simple site-to-site peers.Box 1 has an FXO port connected to the PSTN.If a call comes in from box 2 via the SIP dial-peer, with digits matching the destination-pattern of the POTS d...
Thanks for the reply.Per the following doc, 4 dsl-groups or "lines" can be configured.http://www.cisco.com/en/US/docs/routers/access/interfaces/software/feature/guide/shdslfm.htmlI know the HWIC-4SHDSL will support at least one 2 or 4 wire dsl-group ...
Thanks for the debug commands.I figured it out...I was missing a dial-peer for the SIP leg of the call. The system had VOIP dial-peers for patterns prefixed with '9', but this particular pattern was prefixed with '8' to force the call to the FXO por...
