Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This has probably been asked before but I have had a search and cant find a complete answer.We have 2 x 3750 switches in a stack. We use these for connecting servers that have teamed NICs, i.e. the 2 connections are each connected to a different swi...
Why would there be discrepancies between the ospf database and the entries in the routing table. If I do show ip ospf database there are a significant number of entries that are not shown but are in the network list under router ospf....Why would thi...
Good morningI have been looking at grading the IOS version on our 6509-E however there is not enough space on disk:0 to upgrade to the version I need to install. The question I would like to ask is - is it possible to boot the IOS from a TFTP server?...
I am looking for some advice and help with egard to IOS upgrade.We would like to install a WS-SVC-WISM2-1-K9 in each of our 2 WS-C6509-E chassis. Both of these have supervisor 720 engines installed. One in each chassis.From what I have read we need...
We have 2 site which are currently connected using a layer 2 LES circuit with bandwidth a 1000Mbps. We trunk specific VLans accross this link for management and resources. At each end we have Cisco 6509 switches/routers. We have installed a second...
Hi SudeepYes but cannot see it when I dosh ip ospf database on another router in the area OSPF Router with ID (192.168.162.2) (Process ID 2) Router Link States (Area 0)Link ID ADV Router Age Seq# Checks...
Hi SudeepAs requested#sh ip route 10.115.44.0Routing entry for 10.115.44.0/24 Known via "ospf 2", distance 110, metric 2, type intra area Last update from 10.115.18.2 on Vlan446, 1w5d ago Routing Descriptor Blocks: * 10.115.18.2, from 192.168.16...
Hi RickI am not convinced it is a routing issue either but we have no access lists in place and there isnt a security policy on the end device that would stop connectivity. Some devices on one subnet can connect and others cant so it is a really ra...
Hi SudeepThanks for all your help, I didnt think the ospf problem was necessarily the cause of my problems. However I need to know whay the ospf is not correct.Any help anyone can give is appreciated.Regards
