Level 1
Level 1
Member since ‎04-04-2005

User Statistics

  • 29 Posts
  • 1 Solutions
  • 10 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote
1 Accepted Solution
10 Replies
5 Replies

User Activity

 Same here.  When logging into Sandbox lab i get "Login failed". and prompted for username / password.  I enter again the username password from the email "Your Cisco DevNet Sandbox Lab is Ready and get "Login failed".pls help. !sudo /usr/sbin/openco...
Routes in route table not sent to bgp peer at but only two subnets sent. Need to send them all including default route.   <hostname removed>#sh ip bgp nei  advBGP table version is 1840, local router ID is cod...
Unable to remove the load network config file via tftp.  I find this in the show version on a 3650.  The switch is prepared for IOS upgrade but I found a tftp config file in the show ver.  I dont want to reload the switch as I would rather load the ...
Looking for assistance to get started configuring WAAS on a ISR4351 with built in SM controller. I can not seem to find a interface to setup.  I tried playing with Service Engine interface but not getting anywhere.  Interface              IP-Address...
I have a router connected to MPLS network for Primary access and EZVPN for back.  MPLS and BGP look stable and routing table is stable. Telnet/Ping access thorugh MPLS to router is good but can not reach anything on the LAN side of the router. Not ev...
Community Statistics
Member Since ‎04-04-2005 07:10 AM
Date Last Visited ‎03-02-2023 09:07 AM
Posts 29
Total Helpful Votes Received 5
Helpful Votes From
Helpful Votes Given To