Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am just trying to figure out the output from the following command:sh queuing interface e1/29Ethernet1/29 queuing information: TX Queuing qos-group sched-type oper-bandwidth 0 WRR 90 5 priority ...
Hi all,I have a Radius server for VPN client authentication. However, the Radius is not connected to the Active Directory, the username/passwords for the VPN clients are configured in the Radius itself. I want to know if there is any use doing tha...
Hi all,I have a customer who would like to load-balance between two servers which are each located in different data-centers. I red about the source NAT but I just want to confirm if it's the way to go. The two servers will be on different vlan. W...
Hi all, I have a question regarding the physical connectivity between a P router and a PE router. Some are saying it's best practice to use two 2960G, but I am not convince. Why not connect both P and PE directly? That would probably be more effic...
Hi Jerry,Yes, it's a 5500 Nexus.I apply the service-policy type qos directly on the port-channel use to connect the FEX. I match the packets with an ACL and set qos-group 5 to it. Queing is global and the same policy is use for in and out.I am just...
Sorry I don't have the answer since I have the same question as you. One customer wants to do 15 hub and spoke vpn with a 2610 at the hub. I doubt this can be achieved without seriously impacting performance. Any link would also be helpfulThanksMa...
