Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a customer that is running IIS 6, and needs to source nat traffic from ACE module to those servers. From what I can see, IIS 6 does not support/use “x-forwarded-for” header natively, and require an add-on module. I found only one option (http:...
This is a repost of my question in R&S. Cisco's DCI Design and Deployment Guide Release 2.0 describes an implementation where SP(s) provide a redundant VPLS solution with n-PE, where PWs terminate on a VSS pair at each cust premise. To prevent L2 lo...
Cisco's DCI Design and Deployment Guide Release 2.0 describes an implementation where SP(s) provide a redundant VPLS solution with n-PE, where PWs terminate on a VSS pair at each cust premise. To prevent L2 loop, Cisco recommends implementing EEM sc...
According to the documentation, if you use VPN Passthrough for security, it is also possible to enable the web authentication (normally, for other security methods, this is not possible). My question is - what does that buy you? My suspicion is tha...
A customer demonstrated for a field tech that IP phones (I think they were 7960s, but may have been 7940s) completely restart if a 2-way radio is held nearby and the talk button hit. Anyone hear of this before, and is this a known issue/problem?
No, I'm afraid not. My reference was actually the pdf http://www.cisco.com/en/US/docs/solutions/Enterprise/Data_Center/DCI/DCI2_External.pdf. This describes the need for customer equipment (not nPE) to arbitrate between the two SP-provided VPLS ne...
I am getting a report from a customer that ip forward-protocol is not supported on a Nx5548-UP. I have read elsewhere that this is NOT supported, but being considered. If I read the thread here correctly, the WOL clients, server and dhcp were all ...
So, to clarify, when you tested, did you get 18M, because the srr-queue bandwidth shape cmd was 50% and the srr-queu bandwidth limit command was only 18%, or did the shape command override the limit cmd?
Does this config work? My read of the DHCP setup guide (see link in previous reply to this thread)was that the datatype would be IPADDR, with the array flag set, allowing multiple addresses to be defined.
Maybe I don't understand, but why would a server application be VRF-aware? VRF is a routing issue. Perhaps the real issue is connectivity between your management user's VRF network, the TACACS server VRF network and the 6500 management interface? ...
