Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Gateway connected to 29XX router for SIP Calls, same gateway has FXO port. Can i use the same loopback interface(IP is registered as SIP trunk in CUCM) to bind H323?
Hi, We are facing problem with hearing ring back over PSTN. PSTN PRI----->MGCP GW. When user receives a inbound call over PSTN, the calling party hears busy tone, but the IP Phone/analog is not actually busy. This is happening with internal calls ...
Hi, How can disable the "hook key" in the IP phone? to be more precise, if someone answers a call they shouldn't be able to disconnect it, i have disabled the "Endcall" button in the softkey template. But still the call can be disconnected by off-...
Dear All, Am facing issue with offnet calls not reaching the VM Box. It was working earlier, all of sudden calls are dropped without reaching the VM.Scenario:Extn 1234IP Number: 8881234In a PSTN Cloud 8881234 is mapped to a DID. Users are...
Free call barging..Is the issue happens with only this user or most of the users? E1/T1 trunk ? What protocol is configured for signaling? Is there any ACD in place?
Ensure the device type is selected as 7945 and not 7942 or other models. MAC address has no typo error. Are you trying to register the phone as SIP or SCCP?Do you have correct firmware loaded in CUCM?Is there any other 7945 works fine in the CUCM? Di...
