Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I am setting up my new Defense Center 6.0.1 (VM), which will manage a single 5508X. I am building my policies and am trying to get my realm working. I will run LDAP queries against two Windows 2012 R2 DC's. These DC's use self-signed cert...
We have a 3825ISR with (2) 2-port WICs (V2). Because of internal company/subsidiaries, WIC0 has 2 full PRIs outbound to our carrier's 3945 (dial-peer 9.T), and WIC1 has 1 full PRI outbound to separate carrier 2921 (dial-peer 8.T, with second WIC1 po...
Users are complaining that international calls cannot be made. Recently, route patterns were updated to using explicit patterns, whereas before only 9.911 and 9.@ were defined (with no route filters). I'm not sure if this has anything to do with it...
Just wondering if the 9.@ route pattern is absolutely necessary when all other standard route patterns are defined? When I inherited our CMBE 5000 v8.5.1, all that was in there was 9.@ and 911. I've since added specific route patterns for local/loc...
Call handlers had been set up to send un-addressed messages to the Operator mailbox, which now contains ~600 messages costing almost 200MB. Not a lot in the big scheme of things I know, but wasted space and longer backups nonetheless. I've since re...
Brian, thanks for your replies. I just have one more question... Before setting my clock source to internal on the 0/1/0 interface, should I run the command no network-clock-select 3 T1 0/1/0 first? All assuming I can get the telco to comply, of co...
Brian, thanks for the reply.Is it possible to have one WIC/2 PRIs using clock-source line and the other WIC/PRI using clock source internal? If I am able to convince the carrier to accept us as clock source, that is. I just want to see if it is eve...
I also had the same issue with v8.4.6. An upgrade to v9.1.3 solved the issue. I also was not able to traverse the internal network after making a remote-access VPN connection using Cisco VPN Client.I am not aware of a bug id for this issue, but mov...
Because these settings are changed in the HKCU Registry hive, the settings are per-user. So, if a different user logs in, CUBAC doesn't know about the settings that were already changed for another user.It's unwieldy, but what it means is that you h...
The technical steps I outlined in the OP worked flawlessly. The only hangup I had was with the licensing files. Because the MAC address of the server changes, the license files show as invalid on the new server. The most complicated part of the pr...
