Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I am trying to shape a 10G interface at a full 10G out on an A9K-MPA-8X10GE. I am running 5.3.3. I am able to shape only at a max of 4Gbs...Anything over 4Gbs and the service policy either won't install on the interface or it does install and...
I've been using SIP/SPA 2x1GE with this config for connecting customers:interface GigabitEthernet2/1/0.64 description edge1 bandwidth 100000 encapsulation dot1Q 64 ip address 192.168.2.1 255.255.255.252 ip verify unicast source reachable-via rx allow...
Hi,I'm working on a small LAN with WinXP workstations and a 2621 router as a gateway. Randomly workstations loose connectivity to the gateway. Cannot ping the router interface at fa0/0. If I repair the connection on the workstation it fixes the issue...
Think back...2514 with two serial ports, can I bind two DS1's together with MLPPP on this old platform? I have found references for multi-chassis multi-link but I'm not sure its the same thing.Thanks,Bill
Hi,I need to configure loopback0 for an eBGP router-id instead of using Vlan1's ip address. I know how to do this but my question is, what criteria should I use for selecting what IP goes onto loopback0? This is a production 7609 router we use as a c...
Hi Nagendra, I've tried all these configs below but I've not been able to bring the circuit up. When I enable a subinterface and try to use encap dot1q 3 I get an error: cccoe-edge(config-subif)#encap dot1q 3 Command rejected: VLAN 3 not available ...
Thanks,The dhcp server is on the same LAN as the workstations, doesn't everyone on the LAN look at the UDP broadcasts? I added the helper address anyway and the lease time is 8 days.
Hi,The windows server is the DHCP server. Router is not acting at DHCP.interface FastEthernet0/0 description Local LAN ip address 10.0.1.1 255.255.255.0 ip nat inside no ip mroute-cache speed 100 full-duplex
Thats the thing, I don't have the router with me and don't have access to it. I am trying to do a bit of research before hand. Your answer is right on though, I will try to add an mlppp interface first thing. Can't expect much performance but hey...B...
