IOS change was made to a switch 2960, from version 15.0 (2) to version 12.2 (55) as it presented problems for telnet access and console. However once made the switch and boot the switch with the new image gives the error "Invalid encryption type: 4...
I have a callmanager version 5.1.3 and firmware phone 7911 with 8-3-1-22. This weekend time change was implemented in the country (one hour less), but the phone 7911 does not assume the time change. The other models registered in the callmanager made...
When generating reports indicating no records to display. But when generating a report for the current day (present) if sample information, but passing midnight and can not generate the report of the previous day, and yet if generated if requested a ...
4 agents, only one agent is not displayed on the computer monitor. This is independent of the computer on which it connects. If another agent is logged into the computer with agent problem, with its own, it can be connected without problems and appea...
we have a CUCM 7. integrated with a Nortel PBX. FAC was enabled in CUCM and works well in cisco phones, phones, however the Nortel PBX can not dial when asked the code (fac). Any ideas?, Please, thanks
Thanks Carlo for your answer. The UCCX is a single node, so it does not show the Component Activation hyperlink. Only appears Server Traces and Server Detail as options.
Chris, Thanks for the answer. Was the answer I needed.Chris Deren created thediscussion"Re: block the exit to a specified number"To view the discussion, visit:https://supportforums.cisco.com/message/3643031#3643031
No need to place restrictions. Just assign a resource (FXO) to a group of users and other resources (other different FXO) to other specific users. Both outputs (FXO) have the same privileges.
