Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We're having a weird issue and wondering if someone can identify what's wrong. We've opened a TAC case with Small Business and after many hours and tests we're still confused. It is a very basic set up but it appears like users in the WAP150 G...
ASA 5516-X Capable of Active Active ISPs?
We would like to send some traffic and servers out ISP 1 and others out ISP 2. Currently we have an 1811 ISR Router accomplishing this with PBR.
I just wanted to verify the ASA 5516-X was capable of the same...
I’m dying for some help regarding setting up Dual active WANs on an 1811.
Attached current configuration of 1811 Router (I already started making changes for adding second WAN, which is Comcast on FE1, but it is currently not plugged in and still plu...
Hello!
I've been researching having two ISP connections and I'm getting mixed information from what I've been reading. Overall, it sounds like it is not supported on the ASA 5510, but if someone can confirm that and elaborate why, I'd appreciate it!...
Hi Masoud! Thanks again for the information and help.
I do have some questions though if you don't mind! Since currently the PBR is routing using the PBR ACL by directing certain IP addresses and ranges to be PBR'd or to not be in the PBR ACL, is m...
Hello Masoud and thanks for the response!
I had seen that previously but I still had some questions if I had it down or not.
Based on the current config attached above, I think these are the only commands I'll need to enter, but if you could verify ...
Success!I looked up the error codes for outbound calls and the reason why the outbound calls were not going through was because when I was binding to the loopback I only had " bind media source-interface Loopback1" and not "bind control source-int...
