Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am unable to download asa mibs via the url:ftp://ftp.cisco.com/pub/mibs/supportlists/asa/asa-supportlist.html. Anyone can send me the mibs for ASA5580 ? This is what I experienced after I enable passive mode: Status: Resolving address of ftp.cisco...
We have 12 LAP converted from autonomus AP , it join WLC successfully, but it will leave the WLC in 4 hous, anyone can tell the cause and how to prevent it . versio is 4.2.176
Hi:Recently I convert sup720 from IOS to Catos on SP only, after conversion , the error message of "Cisco WS-SUP720-3B - RELIABILITY DRIVER: wrong signature on NVFLASH" was shown when we reboot the sup720, but funtionlity of layter 2 seems working we...
Refer to https://www.cisco.com/c/en/us/td/docs/security/firepower/610/configuration/guide/fpmc-config-guide-v61/prefiltering_and_prefilter_policies.html , FTD prefilter policy is unidirectional, how to explain it ?
Oh,no lah.Without the permanent ip address,how can you establish the site to site vpn tunnel? Unless you get the static ip address from your ISDN ISP . However , they always provide you the dynamic ip address.
For this case,you install a third party free monitoring software like the MRTG,it will show you the utlization of the interface within a period.Otherwise,using the "show interface serial "command,you check the load of interface ?/255
Thank you very much.But I forgot to mention that configuration was a one way DDR,I set the dialer list one side only.The question is how can I make the other side timeout work .Actually ,the calling side timeout is working well .
