Does anyone know a way of creating a router access list that references an external file sitting on a server, perhaps a text file with a bunch of IP's. The goal is to modify the file to add/remove IP's without touching/logging into the router
Good day all
I am trying to configure PPPoE on a Cisco 2911 router Using an external Radius server (Ubuntu freeRadius). My configs are as below for the Cisco part.
#####################################################################################...
Hi all
i have 2 routers (R1 and R2) connected to each other using 2x 4Mb links from 2 different service providers. i have configured OSPF to load balance traffic on both links, but the router is not load balancing. it is sending all traffic to one li...
HelloI want to use qinq tunnelling in my network. I have 2 cisco 3750 on the edge terminating the qinq tunnels, but in between i have cisco 2960.My question is does cisco 2960 pass qinq trafficThank uSent from Cisco Technical Support iPhone App
hello all. i am trying to do EoMPLS using microwave as my Layer 1. i am doing the same thing using Fiber as my layer 1 and it is working. the minute i use microwave its not working. the EVC will be showing as up, but no traffic will be moving. i a...
Hi Mark
i have done a show ip route with both links open, and another show ip route with best path shut. below are the results. below i have put in bold the difference i can see in the forward metric. how can i manipulate that so that they are equal...
im also facing the same challenge. im using 7200 Cisco router C7200-ADVIPSERVICESK9-M), Version 15.1(4)M2 . the Export option under ip vrf does not include the ipv4 option. regards Promise Kumalo
Yes i can see macs on all devices. What is not working is that if i connect 2 laptops on my qinq ports on the huawei switches i cant ping end to end. If i sustitute the cisco switch with a huawei cx300A it works.Sent from Cisco Technical Support iPho...
the setup is like this SW1<>SW2<>SW3. SW1 and SW3 are the ones terminating the QinQ tunnels. SW2 is just forwardingn the QinQ vlanconfigs for SW1 - Huawei CX 300Ainterface Ethernet2/0/4 description XXX port link-type dot1q-tunnel port default vlan 10...
