Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I'm looking mounting screws, in order to install a webex board on a old design floor stand kit (my client lost them...)
Cisco is unable to sell them, and I didnt find them because I don't know how are they are called...
Is someone has alrea...
Hi everyone!
I've got a strange issue on a webex room kit: when I connect laptops on the Cisco HDMI cable, the touch10 panel don't find the laptop. The HDMI input is set to laptop, on 1080p60. The cable is OK (I test it)), and when I connect a laptop...
Hi all,I'm trying to configure ISR 2901 CUBE with a SIP Trink ISP, and I have several isues: I'm unable to make calls or receive one. I can see that I'm registerd with my ISP, but when I make a call from inside to outside, I've got a busy tone, And w...
Hi everyone,I've got some trouble to use jabber for windows (9.1.3) on a CUCM9.1 (bundled into a BE6K).I have used Cisco Jabber for Windows 9.1.x Server Setup Guide, and when I log jabber, here is the results when I make a connection test:I only want...
This video is currently being processed. Please try again in a few minutes.Cisco Support Community Expert series WebcastCable Modem Termination Systems (CMTS): Architecture, Configuration and TroubleshootingSpeaker: Eric BautistaCisco Support Enginee...
Hi,
The room kit runs under CE9.1 software. I tried with different laptops: native HDMI and Displayport with an adaptator.
I use an HDMI cable provided by Cisco.
Is there a way to disable HDCP on laptop?
Thanks,
Regards
Hi Ahmad,I've just add a new transform to avoid my CUCM call to loop into multiple zone and it's working!WIthout transform, the call went through all the zone I created.Thanks for all.Regards,BZ
