Hi,I wanted to use the UCSPE to test some automation with Ansible and for somethings I need to use CLI commands.Ansible access the remote host via SSH but I can't figure out a way to do this because the only way to get to the CLI via SSh is to login ...
Hi all,
does anybody know is if possib ile to sync the configuration between two WSA in high availability? I didn't find anything in the documentation, probably the SMA is required...
Many thanks
Luca
Hello,I would like to update my Prime Infrastructure installation to the latest 2.0. According to this document I'm trying to install the update pi_1.2.1.12_update.tar.gz but I always get this error:PRIME-0000-01/admin# copy ftp://172.16.14.102/pi_1....
I understand, so basically the HA functionality is only for IP high availability.. no traffic flow is preserved (session table) during the failover (like cisco ASA for example) and no configuration sync is performed..
Probably the standard PAC load b...
Hi Ken,
thanks for the reply.
What do you mean with "automatic"? Are there any other method to sync the configuration (exept manualy replicate and backup/restore)
Many thanks again!
Luca
Ok, I've found the solution. The ftp copy was changing the file each time, so the file was always corrupted once in the defaultRepo.On the ftp server:# ls -l-rw-r--r-- 1 root root 11734212 Sep 25 16:19 pi_1.2.1.12_update.tar.gzOn the Prime se...
