Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Referring cisco document on NAT i would like to know why the acl direction is "dmz_acl in interface dmz" rather than "dmz_acl out interface dmz" as the communication is from DMZ to INSIDE object network dns-server host 192.168.0.53!access-list ...
what is the default ether-channel load balancing method on Cisco switches or does it varies based on platforms? I couldn't find any document that says about the "default" method.
hello,
one of my 4500 switch reports power supply error, "PS mismatch" but what i fond both PS are identical.
Any thoughts or suggestion highly appreciated
Switch#sh modChassis Type : WS-C4507R+EPower consumed by backplane : 40 WattsMod Ports Card ...
Primary requirements:
1. load balancing / redundancy for internet
2. VPN access to LAN from internet
Sienario
some home ISPs provide PPPoE internet connection terminated to the customer home with an RJ45 ethernet, all we need is to connect to PC po...
Hello,I have got an ACE box runing c4710ace-t1k9-mz.A5_1_2.bin and i was trying to downgrade the code to A4_2_2.bin.When i tried to copy the .bin file to :image, it terminates the copying process in the middle with the following message.Step 1:######...
Thank you for the response, here the DMZ is accessing dns host on inside...so the direction is DMZ to INSIDEFrom the document ..What about traffic from the DMZ segment destined to hosts on the inside network segment? For example, a server on the insi...
Thanks bmcginn.If you refer my first post, you see no option of disk0: after system, like below.RSSW02(config)#boot system ?WORD TFTP filename or URLflash Boot from flash memoryftp Boot from a server via ftpmop Boot from a Decnet MOP serverrcp Boot f...
