Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are getting prepared to change our UCS FC mode from Switching to End Host in order to incorporate 2 new MDS 9132 switches and new additional storage. Ive found little info in the way of steps to accomplish this and wondering if anyone that has tac...
I am in the process of adding 2 new MDS 9148s switches to our existing fabrics. We currently have to isolated fabrics. I need to add one MDS to each Nexus. The Nexus currently have 1 VSAN, 1 Zoneset, and is set to basic mode. I want to add the new s...
I have an ASA 5510 that terminates multiple L2L and RA tunnels. I currently have 2 interfaces on the ASA Inside and Outside. I have a default 0 0 route configured on the outside interface to the next hop which is a FW. I currently have reverse route ...
I am setting up a new environment with 2 5548's and some 2248TP-1GE Fex's and Im running into an issue. I have the peer link and peer-keepalive link that appear to be good. When I configure the fex and vpc for the fex manually on each switch without...
Does anyone know what the "Call Failed" actually means in the Hunt Pilot Detail report within CallManager? We are trying to get some reports for the Hunt Pilot to determine if calls are being ansered or not and if not why.ThanksAnthony
Kenny,I'm wondering if you have completed this conversion and how it went. We are in the same boat as you were and need to change to ehm and move the zoning etc to a pair of mds's. If you were successful at completing this any steps or critical thing...
Carlos,
Thanks this is exactly what I was looking for.Another ??? If I want the new switch to be the Principal switch can I set the priority to do so and if so will this changing of the Principal switch in the fabric cause a disruption?
Thanks
Anthon...
WOW. I'm floored. I'm in the process of replacing our Checkpoint cluster in our Datacenter and went with Cisco because I use there routing and switching throughout our environment and its rock solid. Even use ASA's to terminate VPN's. If I wasn't wor...
Jetsy,
Wow what a quick reply. As far as I can tell with my testing there is no outage or unable to connect to hosts. I am using only a few test servers now as I'm planning a second attempt at a cut over from our existing Firewalls. I have provided ...
