Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have seen a lot of information regarding ways to monitor the Status of SIP trunks and currently am utilizing voice-class sip options-keepalive to busy out the dial-peer and EEM to generate syslog and e-mail messages. A significant amout of of...
We are in the process of replacing a pair of 5010's with 5548s. The 5010 is fully loaded including FC expansion module. We have limited rack space avail which prevents us from setting up the new pair of 5548s to support vpc and the...
AllI am attempting to install Citrix Xen server (tried 5.6 and 5.5) on a UCS-B series blade running the Palo Adapter.During the install we are asked to install drivers.I used "kmod-enic-xen-1.1.1j-0.x86_64.rpm" from virtual media and it stated no dri...
We recentely ran into a limit on number of links allowed for devices connected to nexus 2k. Currently there is only support for (1) 1GB link to Each of the 2 Nexus 2k. See Below.The question i have is if this is a hardware limitation or a software li...
We are in the process of installing an ACE appliance for the purpose of compression and acceleration. We noticed aproximatly 50% reducation in sharepoint file download performance when we enabled compression. Upon further investigation we noticed tha...
JeremyThanks for the response. I have been searching around and found both those documents (as well as your blog - great info). The info is not clear as you pointed out. I was not sure if it was support in the recent 5.6 release or if there was a way...
Allan,Thanks for the response.I was leaning toward the hardware side, but this does help provide direction.We were able to design a workaround by creating 2 seperate port channels by creating a 2nd v2witch each with 2 links and splitting the connecti...
Another alternative to PBR is to utilize VRF lite. In many cases this can be easier to configure and troubleshoot. You would create a vrf and put one of the serial ports and one of the ethernet ports into the vrf. this would maintain seperate routing...
Is this interface a dot1Q trunk? If so inbound packets with vlan tags that are not allowed via the switchport trunk allowed vlan command will be displayed as input drops. This is also true if untagged packets are received and the native vlan is not a...
