I have a client with a FP2110 that was ordered with ASA mode.  They also ordered FMC and were intending to configure Firepower services on the FP2110 with ASA similar to how it would have been with an old ASA running FP services.  I can't figure out ...

I have an ASA 5506-X with the Firepower module at v 5.3.1.6 (build 16) and a Sourcefire Defense Center running at v 5.4.1.3 (build 55).  I know, these are both really old.     I've found all of the documentation on upgrading from 5.4.1 to 6.0 and bey...

Is there a way to stop a running backup or at the very least view the status of a backup in PI 1.3?

I have a CAP2602i that I would like to convert from lightweight to autonomous.  Is this possible as with the older APs?  I'm following the instructions for the older models http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrad...

Hello all-I have an 1142 AP that I am unable to set back to factory defaults.Here is what I have done so far:- boot AP while holding down the mode button- ap: delete flash:private-multiple-fs- yes- ap: boot- when the AP boots fully I try and enter an...