Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I want to upgrade a number of Catalyst 3750X-switches and want to do this from Cisco Prime. When I check the recommended image version from Prime the recommended images for both the Catalyst itself and the 10G network module is listed. So my quest...
Hi,
I have a stack of 3850-switches and want to upgrade the switches in the stack by using Cisco Prime. Is it possible to do the upgrade so that one switch is upgraded first and rebooted, and so that the next switch is upgraded when the first is on...
Hi,
I have installed a Virtual Wireless Controller (version 8.3) on ESXi and I am working with the setup. I have a question abount ports and VLANS. Now the controller has only one port, the management-interface is connected to this port. But now I ...
Hi,
I have set up a new installation of a Virtual Wireless Controller version 8.6. I am quite new to this software so I need some help om how to join the APs to the controller. I have connected a new AP to the same VLAN/IP-net as the controllers mana...
Hi, I have a ASA 5525-X with Firepower. We still have some computers in our networks running Windows XP and I would like to block Internet-traffic from these computers. Of course I can maintain the IP-addresses in an access-list and block the traffic...
Hi and thanks for your answer!
I am not sure if I understand this correct. On ESXi I have a vSwitch with multipe VM-networks (VLANS), as shown. The management-network is assigned to the vWLC, but I also want to assign other networks to the vWLC and...
Hi,
I can now see the AP on the vWLC with operational status Downloading. But in the log it seem that the AP has problems with downloading an valid image. From the log I see:
*spamApTask3: Dec 19 11:24:29.718: %CAPWAP-3-TX_ERR: capwap_ac_sm.c:585...
