Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can see only history logs of Users and Interfaces but We just needs some logs which can justify that we haven’t changes anything on the controller.Can someone please take out the Audit logs or change logs in MSE.
Total output drops Show same value on Multiple Interface of 6548GE module in 6500 Switch.
GigabitEthernet2/17 is up, line protocol is up (connected) Hardware is C6k 1000Mb 802.3, address is 0019.56a4.6f38 (bia 0019.56a4.6f38) Description: "PABX SIP-D...
Hi ,
Netconf over sshv2 starts from Cat4k onward, it does not support in 2900 Series..
http://tools.cisco.com/ITDIT/CFN/jsp/by-feature-technology.jsp
Regards,
Adnan
Hi Idris.....
Do below configuration.
ip nat insdie source static tcp private IP ADD 443 Public IP ADD 8443
Verify.
Show Ip nat translation
Troubleshooting.
Router# terminal Monitor
Router# Debug Ip nat Translation
Regards,
Adnan
Cisco found below bug and advised to upgrade.
1. CSCut24730 - MSE 10.X - ERROR com.cisco.mse.persistence.jdbc.JdbcQueryResultSet
This bug causes the system to overutilize CPU and some records might be dropped, as the system has no resources to proce...