Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI all I have a problem with cisco terminal server and putty.I'm working on the terminal server (2801 12.4(24)T4) the arrow keys are working fine.I open a remote line --> arrow keys displays A B C or D???I changed the putty settings to VT100+, VT400 ...
Hi all, I want to create a unidirectional Link between two catalyst 4500X. Switch 1:interface TenGigabitEthernet1/1 unidirectional receive-onlyendSwitch 2:interface TenGigabitEthernet1/2 unidirectional send-onlyend Problem:Switch 1 --> Port notconn...
Hi all, Problem:I want to implement "ip igmp snopping querier xxx.xxx.xxx.xxx" on a Test-Nexus 5596UP.Question:I can't see/implement the command "ig igmp snooping querier ....." on my nexus.Test-nexus(config-vlan)# ip igmp snooping ?*** No matching c...
HiI would distribute a new ios image to Cat2960CG-8TC-L.I have enabled "insert boot command" and Reboot Device: "Immediately.Copy image to the device: OKReboot device: OK but with old image.Job Status:Validating device distrib...
HI @llThe Cisco Prime 1.3 shows all Switches in the Device Group "All", but in the device group "Device Type" I see no switches, routers.I think cisco prime creates rule-based device groups and assigns devices to the appropriate Device Type folder.Ci...
I can't hardcode speed and duplex on a port with 10Ge sfp+ transceiver.On different ports same problem (1GE sfp works, 10GE sfp+ doesn't works) Thanks,Bernhard
