Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have deployed a couple of Mobility Express environments with 1850/1830 series APs. I have the AP-s connected to some Cisco SG300 where we have a printer with airprint enabled. Airprint does not seem to work. I had similar issues with the t...
Dear All, I have UCCX 8.5 with standard license. I have deployed an ivr for the call center, I need to add another one for the IT.Can I do this on the same server? Regards,Ibra
Dear All,I have upgraded from ACS 3.3 to ACS 5.4. I had ASA configured as tacacs client, with several AAA Server Groups referencing to the groups in the ACS local database and mapped groups from AD. Each group was used for diferent services, i.e Remo...
Dear all,I am having a problem with RTP packets. I have deployed cucm 8.6, and for some reson its response time is very variable even whe I ping the server from inside the vlan. ( there is almost 20% packet loss ).Reply from 192.168.223.100: bytes=32...
I ran into this thread while testing some templates, so here is what works: While you can't remove the eth0, you just need to add another feature template of type "VPN Interface Ethernet" for eth0. Just keep all values in the template as default and ...
I found a link explaining the maximum capacity:http://www.cisco.com/c/en/us/products/collateral/customer-collaboration/unified-contact-center-express/data_sheet_c78-629807.htmlThe information needed is in table 7. Regards,Ibra
According to this guide:http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.3/user/guide/policy_mod.html#wp1075731ACS 5.x cannot use identity store elements as conditions for service access selection rules. I solved the prob...
