Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I'm no DC expert, need some guidance.
We're currently connecting 2 small DC's using Cisco N7K with OTV running to extend the VLANs. They're connected using 1 link from 1 provider (1 Gbps layer 2 link with jumbo frame). Customer wants to add a sec...
Hello, We've a brand new Cisco vEdge 2000 that is in a continuous loop when we start it (TLB exception load/fetch), it keeps the log below over and over never ending. Is there something that can be done to try to recover the box? I believe this is so...
Hello everyone,Im currently working in an implementation of a new network (via MPLS and Internet) and we noticed that the MX64 takes a long time to register on the Dashboard for the first time, it varies from 15-20min to 40-60minutes. It´s almost one...
Guys, I´m new to ASA FW, Im facing some difficults to get it work correctly.
Issue is, this was moved by customer and he has no documentation at all. All cables everything was disconnected.
Anyway, right now I cabled it like this:
SWITCH <-------> ...
Hi all...I've a Cisco Router 2921, in fact a C2921-CME-SRST/K9 which is damaged, not booting at all.We do have in our warehouse a new pure C2921.I wonder, is it possible to migrate de CME-SRST/K9 license from the old to the new C2921?If so, how? Thro...
That might be right, I´ve no access to the proxy to know what´s going on in there.At the firewall level it seems just fine, but I can´t tell the same for the proxy.I believe a good test would be use an internet connection via a 4G router and see what...
Hey Adam,Thanks, but yeah, I don´t think it´s related to the firmware, as, once it registers itself, I can check on the uplink traffic the time it starts and the time it finish downloading the firmware, less than a minute after the uplink traffic goe...
Hello Francesco, how are you?
Thanks for the input!
In fact, I tried to remove just to make sure it wasn´t blocking.
Just configured the access-group back, it still the same, no access from switch to router.
Those are the lines I´ve added (pretty muc...
Thanks Giuseppe!I will try that...But it's a huge fail if Cisco says that it supports everything and leave the most used protocol out of the IOS... I just can't believe that!Anyway... I'll give a shot and let you know!Cheers,Caue Wailemann
yeah... 3 switches, 4, 5... I just finished the installation of a stack with 7 3750 switches and it worked just fine...What do I usually do... I just power-up each switch individually without the stack and them I assign to it the priority and the swi...
