Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am installing a network that has two SG500X-24 switches as core and several SG300-52 switches as access switches. I've seen in the SG500X-24 datasheet that there is a True Stacking feature. But in the data sheet there are not a lot of details about...
I am testing a record software for Cisco IP Phones. This software must receive voice traffic from mirrorred ports on a 3560 switch. I´ve configured the span ports in this switch, but the only traffic I can see is broadcast and multicast. I did...
I am trying to upgrade the SCCP firmware of a 7941 model, but the display locks on a upgrading message.The new firmeware´s version is 8.X and the old one is previous from 7.X .I found some Cisco documents that warned about the impossibility of a dire...
Is it possible to compress the RTP, UDP and IP headers of a voice packet under a VPN IPSEC connection? These headers are encrypted when IPSEC is set to use ESP.Best Regards.
Is there any integration between UCCX and Webex Chat?I ask because I wanna know if it is possible to deploy a chat infrastructure between customers and UCCX attendants. It is common to see on the web pages a "Click here to talk with an attendant" par...
Tom and Ivor, thanks for the assistance.I will have to figure out how to configure these devices to work like a single device.I found some useful information on the SG500X administration guide (http://www.cisco.com/en/US/docs/switches/lan/csbms/Sx500...
Hi.I tested with my own notebook. I used wireshark and packetizer sniffers. With no "encapsulate replicate" option (command "monitor session 2 destination interface fa0/48"), i see only broadcast and multicast traffic. I changed the destination port ...
Hi.I´ve tried this already, but I did it again. I´ve upgraded too the ios to 12.2(55)SE1-C3560-IPBASEK9-M version.After the command is done (monitor session 2 dest int fa0/48 enc replicate), I can see no more traffic, neither broadcast, nor multicast...
Hi, Reghunath.I´ve tried vlan 51 at mirrorred port (port 48), but it didn´t work. I still am receiving only broadcast and multicast traffic.Best Regards.Fujimura.
I took off the spanning tree portfast from the destination port (port 48). In this port, there are only settings for speed (100Mbps) and duplex (full) that match the server´s interface configuration (100 Mbps, full duplex ). I changed already monitor...
