Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco 3750-48p, Loads ios ok and then all the checks pass test and then after "waiting for port download...complete" shows the device info as seen below and then hangs at that point.
File "flash:c3750-ipservicesk9-mz.122-55.SE10.bin" uncompressed an...
I have been tasked to implement port security for specific vendors. We do not know what the MAC address is prior to them plugging in but we do know the vendor portion of the MAC. Is there any way to apply a wildcard filter for these vendor MACs in po...
We have several of these 7925 wireless IP phones and when we converted our lines to SIP the issue started. Whenever a call is answered on one of these wireless phones it is one way audio. Same call answered on a desk phone is fine.
I have several executive assistants that want to know why the call history is not cleared on all shared lines when they clear all history on one of their phones.Example: Denise has line 256747, Sharon has line 256747, and Patricia has line 256747. Wh...
I am having a difficult time getting wallpaper to show up on the 8941 phones. I have a 8961 with the exact same setup in terms of tftp server. The 8961 shows all the wallpaper just fine but the 8941 does not. According to Cisco documentation, they bo...
Similar issue for me. I applied to "switchport trunk native vlan 192" from vlan 1 and lost it. Had to go power cycle the switch to revert config to last saved. But it never came back and now I have this same problem reported here. It does nothing at ...
Was this ever resolved? I have the same issue with a 7925 and 8865 sharing the same DN. The call comes in and is answered in the 8865 but continues ringing on the 7925. Is this a SIP vs SCCP issue?
I formatted the flash already. Doing the fsck flash: did not find any errors but did see a directory which I dont see listed. Copying the IOS image via xmodem again. Will be about 4.5 hours.
switch: fsck flash:Are you sure you want to fsck "flash:" ...
Yes, I am able able to get to recovery mode while holding the mode button on power up. I am able to read the flash with no issue. I thought maybe the IOS image was corrupted so I deleted and copied a newer version via xmodem. I booted with the new im...
