Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I'm trying to register WAAS Express and follow that guide -http://www.cisco.com/c/en/us/products/collateral/routers/wide-area-application-services-waas-software/deployment_guide_c07-713403.htmlbut after running on router -Waas cm-register https://...
Hello!As mentioned in documents "All FabricPath VLANs use conversational MAC address learning."Here my configuration-vlan 100-200,252 mode fabricpath Configured 2 interfaces vlan with ip addresses- n7k-right-bor-core# sh ip int br | exc unasIP Inte...
Hi,i'm trying to restrict access to supervisor module mgmt0 port and follow http://www.cisco.com/en/US/docs/switches/datacenter/sw/best_practices/cli_mgmt_guide/N7K_CLI_Mgmt_Best_Prac.pdfAccess ListIntroduced: Cisco NX-OS Release 4.0(1)The supervisor...
Hi,i try to install n1k VSM on Cisco UCS server(4Gb memory free).Due installation i got messgae-An error was received from the ESX host while powering on VM Nexus1000V-VSM-PDC.Failed to power on VM.Could not power on VM : Admission check failed for m...
Hi,yes, i fogot to add port 8443 intoWaas cm-register https://x.x.x.x/wcm/registerBut now i have another error-%WAAS-3-WAAS_CM_REGISTER_FAILED: IOS-WAAS registration with Central Manager failed for the following reason: HTTPS request does not contain...
Hi, sorry for delay-here information you asked for.Here an ESXi boot hangsfnd after it next screen-Information about firmware here. I had same problem with previous UCS Manager firmware and server's firmware.After it i upgraded but it did not resolve...
Configuration for Single 10 Gigabit Ethernet CardAlthough it is possible to use a single 10 Gigabit Ethernet card on the Cisco Nexus 7000 Series for both core connectivity and the peer link is possible, it is not the most desirable option. If you los...
Hi,i think problem is in another field....Here my scheme-Cat6k is ROOT for VLAN1 and all ports are in FWD state.C3925: F0/0/0 is FWD ( connected to SUP1 g1/2) and F0/0/1 is BLK (connected to SUP2 g2/2).But SUP2 is ACTIVE(strange that f0/0/1 on C3925...
