Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'd like to know if is it possible to verify a traffic in a subinterface of a port-channel.When I perform a show int portx.x the traffic is the same of the original port-channelcsco-dist-bnu01#sh interfaces port-channel 24Port-channel24 is up, line p...
Mar 26 19:32:39.557 GMT-3: %BGP-5-ADJCHANGE: neighbor X.X.X.X Up Mar 26 19:32:40.741 GMT-3: %BGP-5-ADJCHANGE: neighbor X.X.X.X Down BGP Notification sentMar 26 19:32:40.741 GMT-3: %BGP-3-NOTIFICATION: sent to neighbor 200.219.130.253 3/11 (invalid or...
Hi,I have the following scenario, 1 x 7600 that I need to manage this router using VRF (because I dont't like to mix the routing table) I configured a giga interface using VRF and worked fine, but I also need a back-up interface in the same net of th...
Hi Jon,I'd like to know how much traffic is passing on a subinterface of a portchannel.If you see the show commands they only show the traffic on the main port-channel
Hi The IOS is sup-bootdisk:s72033-advipservicesk9_wan-mz.122-18.SXF7.bin and the config are neighbor REGISTRO remote-as 64548 neighbor REGISTRO shutdown neighbor REGISTRO update-source GigabitEthernet1/1.854 neighbor REGISTRO next-hop-self neighbor...
Hi Andreas, the port-channel must be L3 in my topology.Cisco told me doesn't support yet link bundling in MPLS TE (http://www.ietf.org/rfc/rfc4201.txt).
