Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,
i was stepping on the following issue.
The ASR1001-X is EoL, the repleacement product is the Catalyst 8500L. However C8500L does not support CUBE but ASR1001-x was.
CUBE guide suggests using the C8300, however these boxes have diffrent hw-s...
Do you have Umbrella enabled ?if so you need to create VPN exclusion rules in Local internet breakout.otherwise traffic vom the NAT-Client will be send into umbrella and will be blocked.this is however only configurable in SDWAN hub-mode.
I think for this requirement you can use the MR36H Model very good.It comes with a second LAN port which you can connect to your switch and the MR36H joins the WiFi like a client. You can also bridge diffrent VLANs.https://documentation.meraki.com/MR...
If the MX does use automatically WAN2 when WAN1 goes down and you are connected to either a Cisco ASA or FTD. You can simply configure the tunnel on the ASA/FTD twice.If WAN2 does not answer to the ASA/FTD as long as WAN1 is working only one tunnel i...
Thanks Jonathan,
we will contact our account Team.
As a quick and available solution we will use the C8300-2N2S-4T2X with C-NIM-1M (Cisco Catalyst NIM Module 1-Port 2.5mGig with PoE) as OOB MGMT Port.
Thanks
Yves
Hi Folks, this is the difference, the smart transport is the new one and the call-home is legacy, both is available since some products dont support the new client "smart transport".
