Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA 5515-x and added module ASA-IC-6GE-SFP-A. From the CLI, the interface is showing as GigabitEthernet1/0, and when I enter the command "media-type SFP," it says invalid input. The ASA has an SFP connector, which is up and running. Is ther...
I'm trying to split VPN traffic for our phones and remote users into different ASA's. This is due to the cert assigned on the outside interface of ASA1. Currently, ASA1 outside interface has the cert for the VPN phones and when users tried to VPN the...
Hi,
We have a stack 2960 and all phones are Cisco 9951/9971. I'm looking at the config and all these commands are in an interface. Is it an overkill to have mls qos trust device cisco-phone, mls qos trust cos, and auto qos voip cisco-phone command ...
Hi,
We currently have bonded T1s 3M (this is the only option) in one of our sites and we're in the process of upgrading to 6M, 4-bonded T1s. This is a remote site and I will be visiting in the next few days. My questions are...
Can I install an addit...
We have IP Communicator and CUVA installed and both works fine when the user is in the internal LAN but CUVA does not work when the user is connected via VPN (IP Comm is working). I've created an ACL that allow UDP 5445, 5446, and TCP 4224 but CUVA i...
I have an SFP connector (Cisco GLC-LH-SM - 1000BASE-LX/LH SFP) installed. So, from what you're saying even though from the ASDM or CLI that the interface is showing GigabitEthernet it's actually SFP? Thanks
Rick, one more thing. Do I need to create an ACL (on the 2901) to specify traffic VPN phones (2.2.2.2) to ASA 1 and remote users (3.3.3.3) to ASA 2 or the NAT will suffice? Thanks
