Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1 of the 4 WiSMs here reboots itself when the web GUI is started. The other 3 do not do this.
sequence:
1. type in it's IP @ in a browser while you have a CLI session for it open
2. the CLI shows it go offline and then starts it reboot
3. obviously, ...
VOIP guy is at a conference. A dept mgr is asking for the ACD they use to have the "open hours" changed for their group that uses ACD. Running v8.5 CUCM. I can't even find ACD in CUCM or UCCX. Google comes up only with CME related answers.
Is the mgr...
Users created in Qradar do not authenticate. Qradar is configured to use RADIUS and CHAP to authenticate the users in ACS. ACS v4.2 does not seem to allow a client to be configured such that Qradar must authenticate with ACS via CHAP in order to then...
This can't be right, it's on our 2951. I don't have another router to compare with, but shouldn't g0/1 have the same MAC listed for it's MAC and the bia?GigabitEthernet0/0 is up, line protocol is up Hardware is PQ3_TSEC, address is f866.f2dd.8820 (b...
The documentation here:http://secret-epedemiology-statistic.org.ua/1587052091/ch03lev1sec1.htmlsays the reset button is:a multifunction switch. It provides the following functionality: If pressed longer than 1 second and less than 5 seconds, the sys...
A reboot of the WiSM fixed this.
It seems not all reboots are equal. When it was crashing/rebooting, that reboot never fixed this but this plain old reboot did when not preceded by an invocation of the GUI in a browser. Thanks.
After more looking around in CM, there is a line group associated with this ACD as you can see in the attachment. I wanted to assign a time schedule to it but looks like that isn't even an option. I did create time period and schedule. Next I'll look...
