Hi,
I would like know whether there are hardening documents based on specific OS for cisco products for eg. Nexus, IPbase, Lanbase, ADVENTERPRISE. As some of the hardening commands are not supported on all the different versions.
Hi everyone, We have a standalone 3750 Stack switch for which we were facing some extended access-list latency issue, for which we reloaded after 2 Years. After reload, the switch got power cycled 2-3 times, also the master switch went ...
Hi,I have a pair of 6509 switches running IOS 12.2(33)SXI4a. These switches are connected through a port-channel. A vlan is configured on both switches (vlan id 6). Servers are dual homed on these switches. I have not enabled multicast routing on the...
Hi Guys,I have four 6509 switches connected in full mesh. The IOS is 12.2(33)SXI4a. Spanning tree mode configured is RPVST+. The switches are connected using fiber cables.UDLD default hello interval is 15 sec. Going through Cisco documentation regard...
Hi Duyen,We have observed some fabric tests fail on certain modules. After switching between Active and Standby SUP the diagnostic tests did not fail.We could not conclude the exact reason for the behavior, but the problem was attributed to some misb...
