Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We bought a lot of AIR-DNA-E-3Y licenses a few years ago together with 9115 APs. We have never used Smart-licensing so the licenses has never been used. Now we bought two 9800 controllers and using 9172 APs, and have enabled Smart licensing on the co...
Two WLC 9800 N+1.Enable AP Tag Persistency is enabled on both controllersIf I set a Policy Tag on an AP and write the tags to the AP when it is joined to WLC 1, and it then joins WLC 2 it will keep the tag setting. If I then set another tag on the AP...
We have a device with static IP connected to a Remote LAN on a 1815W, that we cant communicate with. I guess it behaves as a passive client.All guides I can find about passive clients are about clients connected to WLANs. Is there a way to get passiv...
We have about 600 AP1832. They typically draw about 5-7 watt of PoE. Now we have had a few that suddenly draw 14-15 watt, gets hot, and then dies after a few weeks. Seems like a harware faliure. They are a few years old so no warranty left.We cant fi...
We have configured a remote Lan on the AUX-port of a 2702, configured as a flexconnect AP. We have connected a switch to the port, but it seems that it only can be one MAC address on the port ? It only says one client connected, and only one device c...
Yes, the AP is first configured with Policy tag "Hospital" on WLC 1, then I change primary controller (High Availability) for the AP to WLC 2. When it has joined WLC 2 i configure Policy Tag to "Highschool". So now depending what WLC it joines it wil...
Hmm...ok.Two WLC in N+1 setupBoth has policy tag "Hospital" and Highschool". An AP is installed at the hospital, joins WLC 1and is configured with tag "Hospital" and the config is saved to the AP.Later the AP is replaced and instead installed at the ...
Yes, but I would like the AP to keep the Tag that is saved to the AP, whatever is saved locally on the controller it joins. If the AP has been configured with another Tag earlier on the controller it joins, the Tag that is saved to the AP should over...
We have now solved the problem with a workaround. We have put a switch at the remote location and connected the device to the switch, and then put a static route in the core pointing the device ip to the switch.
