Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone. I just got IPS module replaced (waranty) on asa 5520 i wasnt able to do notyhbng with it unless i changed my time on a laptop and put it to 05/2003 then i was able to update os and acces it thru ASDM/IDM.The command "set clock" is mis...
Hi there.I have a 2 5525x configured as active/standy and bot IPS modules configured with defaults there is no internet connection to them and no traffic passing thru , but IPS show memory usage 80% is that normal ?
hello everyone im using the ASA 5510 for routing i just added webcam and cant get it working from outside i have a static nat from outside to insideand access list allowing from outside se attached pictures
Hello i have a ASA 5525x im in testing proccess and cant make internet routing working im routing between 2 private ip cuz outside interface is connected to the lab switch.im able to ping anything from ASDM als i tried packet tracer using the ip that...
THe phone system is managed by Auxion company but i have a QOS on ASA 5510, Phone Company Stating that the problem in Qos or ISP but nothing has been changed in ASA Qos , any ideas if ther is missconfiguration ? !class-map VOIP match rtp 10000 16383c...
the only way to change the IP address is to login to the IPS module.If you IPS show all UP the commands are :sensor#conf t service hostnetwork-settingshost-ip X.X.X.X/24,DefaultGatewayP.S add ACL allowing management from same network or just reimage...
http://www.cisco.com/en/US/docs/security/ips/5.1/configuration/guide/idm/dmSgEng.htmlhello here is the topic for SNMP tweaking so it will identify Brute force attack
Hello . 1 st you need to connect interface on IPS (Management only) to your switch and have proper routing if it uses different subnet (other than ur LAN)2. to identify the ip address do following ASA# show module 1 detail --- it will show all config...
