Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About ditti.tech
06-28-2019
ditti.tech
Member since
10-31-2007
Beginner
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
in Smart Net Total Care Portal and Collector Discussions
06-27-2019
02:26 AM
06-27-2019
02:26 AM
Thanks for your reply
... View more
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
in Smart Net Total Care Portal and Collector Discussions
06-26-2019
06:52 AM
06-26-2019
06:52 AM
We have spare equipment not connected to the network and we would like to add it to the CSPC or SNTC. Is there a solution?
... View more
Created by
ditti.tech
in Other Network Architecture Subjects
in Other Network Architecture Subjects
12-18-2018
08:26 AM
12-18-2018
08:26 AM
In a configuration with 2*40Gb VSL links, is it recommended to cross-connect the VSL links ?
Chassis1 Slot3 ->Chassis 2 Slot 4
Chassis1 Slot4 ->Chassis 2 Slot 2
And the dual-active links are on the supervisor or an another card ?
Thanks
... View more
- Tags:
- vss
Labels:
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
in Smart Net Total Care Portal and Collector Discussions
06-13-2018
07:58 AM
06-13-2018
07:58 AM
After a reboot of the server CSPC, the filter work fine
... View more
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
in Smart Net Total Care Portal and Collector Discussions
06-08-2018
07:57 AM
06-08-2018
07:57 AM
Y es that was done.
Regards
... View more
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
in Smart Net Total Care Portal and Collector Discussions
06-08-2018
06:41 AM
06-08-2018
06:41 AM
It's same menu, look print screen, but it doesn't work
I have the version 2.7.3
... View more
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
in Smart Net Total Care Portal and Collector Discussions
06-08-2018
02:23 AM
06-08-2018
02:23 AM
Hello,
I have a discovery job schedule every day with a lot of IP Address:
10.100.0.0-10.100.15.255
This work fine.
Now I want to unmanage 2 IP in this range :
10.100.1.100 / 10.100.6.12
I include this IP in Device Management > Credential Management > Do Not Manage Devices List.
But after each discovery, the IP come back
Is there a way to exclude IPs ?
Thanks
... View more
Labels:
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
in Smart Net Total Care Portal and Collector Discussions
05-18-2018
01:41 AM
05-18-2018
01:41 AM
Hi,
I would like to schedule a report as a csv file but we can't select csv, is it possible ?
Actions - Schedule Reports - Custom Inventory Report (view screenshot)
However, if we go through :
Library - All Hosts - Export, we can export to csv
Thanks
Nicolas
... View more
Labels:
Created by
ditti.tech
in Wireless and Mobility
in Wireless and Mobility
01-03-2018
01:59 AM
01-03-2018
01:59 AM
Hi
I would like to upgrade my P.I. 3.1 to 3.3 in setting up a new VM and restoring my application backup. As the map system in the new prime is quiet different is there a possibility to make a application backup or restore without the maps ?
Thanks
... View more
Labels:
06-16-2014
06:19 AM
http://www.microsoft.com/en-us/download/details.aspx?id=40319 Extract page 8 Windows NIC Teaming always operates in LACPs Active mode with a short timer. No option is presently available to modify the timer or change the LACP mode.
... View more
06-16-2014
06:00 AM
Since Windows 2012 Server, Microsoft natively integrated the Load Balancing/Failover (LBFO) into the operating system. Unfortunately, in an "802.3ad" configuration, the LBFO is fixed at Short Timeout (every 1 sec) and it cannot be changed. As a consequence, we have an incompatibility with our Cisco Nexus 5000 to perform an In Service Software Upgrade (ISSU) because we need to negotiate a Long Timeout (every 30 sec). To work around this problem, we passed by the new version of the Broadcom BACS or Intel ANS with latest drivers and not use the MS LBFO.
... View more
Created by
ditti.tech
in Server Networking
in Server Networking
06-13-2013
04:42 AM
06-13-2013
04:42 AM
On linux it's really simple... lacp_rate= Specifies the rate at which link partners should transmit LACPDU packets in 802.3ad mode. Possible values are: slow or 0 — Default setting. This specifies that partners should transmit LACPDUs every 30 seconds. fast or 1 — Specifies that partners should transmit LACPDUs every 1 second.
... View more
Created by
ditti.tech
in Server Networking
in Server Networking
06-13-2013
04:11 AM
06-13-2013
04:11 AM
Hi, How to change LACP timer-value on Windows server 2012, from short to long? Regards ######################################################################## 2 nexus nexus5k in VPC dmain and Single-Homed FEX N2K-C2248TP-1GE Layer 2 requirement— The ISSU process will be aborted if the system has any Link Agregration Control Protocol (LACP) fast timers configured. # show lacp issu-impact For ISSU to Proceed, Check the following: 1. All port-channel member port should be in a steady state. 2. LACP rate fast should not be enabled on satellite member ports. The following ports are not ISSU ready Eth102/1/1
... View more
Labels:
01-23-2012
03:51 AM
Thank you, the serial port of Supervisors is connected to a Cyclades console server. The break séquance is: %break and "Carriage return"
... View more
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
3 weeks ago
3 weeks ago
Thanks for your reply
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
3 weeks ago
3 weeks ago
We have spare equipment not connected to the network and we would like
to add it to the CSPC or SNTC...
Created by
ditti.tech
in Other Network Architecture Subjects
12-18-2018 08:26 AM
12-18-2018 08:26 AM
In a configuration with 2*40Gb VSL links, is it recommended to
cross-connect the VSL links ? Chassis...
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
06-13-2018 07:58 AM
06-13-2018 07:58 AM
After a reboot of the server CSPC, the filter work fine
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
06-08-2018 07:57 AM
06-08-2018 07:57 AM
Yes that was done. Regards
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
06-08-2018 06:41 AM
06-08-2018 06:41 AM
It's same menu, look print screen, but it doesn't work I have the
version 2.7.3
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
06-08-2018 02:23 AM
06-08-2018 02:23 AM
Hello, I have a discovery job schedule every day with a lot of IP
Address: 10.100.0.0-10.100.15.255 ...
Created by
ditti.tech
in Smart Net Total Care Portal and Collector Discussions
05-18-2018 01:41 AM
05-18-2018 01:41 AM
Hi, I would like to schedule a report as a csv file but we can't select
csv, is it possible ? Action...
Created by
ditti.tech
in Wireless and Mobility
01-03-2018 01:59 AM
01-03-2018 01:59 AM
Hi I would like to upgrade my P.I. 3.1 to 3.3 in setting up a new VM and
restoring my application ba...
06-16-2014 06:19 AM
http://www.microsoft.com/en-us/download/details.aspx?id=40319Extract
page 8Windows NIC Teaming alway...
06-16-2014 06:00 AM
Since Windows 2012 Server, Microsoft natively integrated the Load
Balancing/Failover (LBFO) into the...
Created by
ditti.tech
in Server Networking
06-13-2013 04:42 AM
06-13-2013 04:42 AM
On linux it's really simple...lacp_rate=Specifies the rate at which link
partners should transmit LA...
Created by
ditti.tech
in Server Networking
06-13-2013 04:11 AM
06-13-2013 04:11 AM
Hi,How to change LACP timer-value on Windows server 2012, from short to
long?Regards################...
Created by
ditti.tech
in Switching
01-23-2012 03:51 AM
01-23-2012 03:51 AM
Thank you, the serial port of Supervisors is connected to a Cyclades
console server.The break séquan...
Public Statistics
| Date Registered | 10-31-2007 02:39 PM |
| Date Last Visited | 06-28-2019 12:02 AM |
| Total Messages Posted | 18 |
| Total Helpful Votes Received | 9 |
