You can visit the following link to get the release key of TC7.x:www.cisco.com/go/licenseThe serial number of the unit should be under an active contract. If you only get an option of TCNC key on the web page, you might need to engage your Cisco Sale...
Hi, To my knowledge, SIP should be used as the default protocol while placing calls. ISDN Link installation guide mentions the following config on the end-point:Endpoint configuration - Use the Remote Control or Touch panel to configure.• IP Assignme...
As per SX20 admin guide, DVI port of the codec should support 1080p for presentation. Try changing the DVI input type from Auto to RGBAnalog, although it shouldn't make a difference.Apart deom that, if your content doesn't have much movement involved...
All Codec 6000 with revision 3 or later support the PHD-S camera. Older version might also work but you will need to connect a separate HDMI cable to it and try. Older versions didn't had the proprietary connector (also known as THSI) which carries p...
Far-end receives two seperate video streams and you should be able to switch between different layouts on far-end to change the view on monitor.The call bandwidth will always be less than the default bandwidth allocated while placing the call. When p...
