Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
This morning we had a bunch of Cisco 8831 devices showing phone not registering and once we removed the Ethernet cable and put it back in they came back up and registered. Any idea why would this happen ?
These 8831 devices are connected to Ci...
Hi,
We have a small site with a single L2 3850 switch connecting to an CE router. Currently there is two vlans (2 & 3) on the switch and the interface g1/0/1 connecting to the CE router is only an access port for vlan 2 traffic. We now need to carry...
Help,
I working on replacing 3750 stack switch with 3850 stack switch at a remote site and currently the 3750 stack switch is running eigrp as the internal routing protocol. My plan in a nutshell is to change it from EIFRP to OSPF(company standard) ...
HI,I need to capture the traffic on several (specific) IP addresses using my laptop as the distanition using WireShark. I have my span ports all setup on the switch side I just need some help on setting up the filter with Wireshark where all I want t...
Mohammed,
Thanks for the info I do appreciate it.
I'll speak to the voice team and find out if they have RTMT installed and do as you recommended.
Thanks,
Jack.
Mohammed,
Thanks for your reply...
I checked the switch uptime and it's been up for over 3 months and I checked the logs as well didn't see anything alarming. Im not a voice guy but what is the RMTM ?
Thanks,
Jack
Jimmy, Srory for the late reply but it turned out to be we needed to add the missing auth data vlan command on the switch. After that the error went away.Thanks for you input I do appreciate it.Jack.
Thanks for the info I appreciate it. I do have another question in regards to the 3850 switches I have 4 switches stacked as one and I noticed in the config the redundancy mode is set to SSO and and i do see 2 members and one standby and one active....
