Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ALL , GOOD Day all of you .I am facing a big problem i.e standby PRI not working with VG & CUCM , I have checked all the configuration parameter on VG & CUCM found ok but I am unable to make any call from standby link also incoming no...
HI ALL ,Can I enable call back feature on CUCM Ver 7.1 , but I am trying to create softkey template for call back but not created soft template on cucm ver 7.1Does this feature is support in CUCM ver 7.1 for Cisco 7940 serious IP Phones .I am trying ...
HI ,I am going to upgrade CUCM IOS ver from 7.0.2.20000-5 up to 7.1.5b(Su5) . but at customer end two CUCM is configured in Cluster .one is publiser & seconf is Subscriber .I want to upgrade publisher from 7.0.2.20000-5 up to 7.1.5b(Su5) , after I...
HI ,I am going to upgrade CUCM IOS ver from 7.0.2.20000-5 up to 7.1.5b(Su5) . but at customer end two CUCM is configured in Cluster .about this activity i have some queries as follows .1) I am don't know the IOS up gradation procedure . kindly share ...
HI ,I am going to upgrade CUCM IOS ver from 7.0.2.20000-5 up to 7.1.5b(Su5) . but at customer end two CUCM is configured in Cluster .about this activity i have some queries as follows .1) I am don't know the IOS up gradation procedure . kindly share ...
Hi Craig ,Thanks for your reply .We are using the full 30 channel E1 PRI . following are PRI Channel Statistics: %Q.931 is backhauled to CCM MANAGER 0x0003 on DSL 1. Layer 3 output may not apply ISDN Se0/0/0:15, Channel [1-31] Configured Isdn Int...
HI Yosh ,Thanks for your support , it has been done ..I have one query about that , let us see user A & user B , User A is connected to other user i.e Z user , When User B is calling to user A , User B only listen rings , But there is any another Fea...
Hi All ,I Have created a softkey Template reference to the above document but unable to see any option to change layout of this template .After creating softkey template , there are two option one is add application & second is remove application .Pl...
Hi Aaron,Thanks for your reply ! Could you let me know how to enable 'Extended Functions' service on CUCM. Do you see the softkey on the phone?>>No I have not seen the softkey on phone .BR,SANDIPAN
