Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello:We are building a Network that connects two sites via dark fiber with a distance of 274KM. On each End there are 7609 with 10GB ethernet cards with 10G-Base ZR (80KM maximum distance). What devices can I use to amplify the signal through the f...
Hi!On an IPCC Enterprise solution, how can I get SMS (messages to mobile phones) functionality from the agents desktops? Is there an additional module that have to be purchased?thanks,Mario S
Hi!I have a NM-6DM with MICA modems. While fine tunning the modem I changed some values which now I want to save. I have tried the at&w, at&w1 and at&w2 but I keep receiving ERROR.Any helpthanks,Mario S.
Hi!I want to know if it possible to install the Open View Operator Client on the Cisco Media Convergene Server. Have anyone tried this? Is this prodecure documented somewere?Thanks,Mario
Hi!I am planning to upgrade my WLAN security wo WPA and LEAP. I tested LEAP on W2K with ACS and it works fine. About configuring WPA, do I need a supplicant for Win2K and WinXP? Where can I get it?Can someone post a link abount configuration of the A...
Formally the answer is no. You are installing in a new server and it requires a new OS. If you have a service contract then you can generate an RMA for the SW Kit and request a New Kit for 7845. Just make sure to return the 7825/35 SW Kit with the CO...
Hi!I think its safer to statically configure the trunk ports rather than leaving them to negociate trunk parameters. Just set the trunk to on and configure dot1q as encapsulation. Some Cisco switches dont support ISL (really) so 1q is a better option...
There is not much of an issue to have the native VLAN as 1. Just be sure your trunk ports have native VLAN 1 in all of them. One of the reasons of not using VLAN1 for passing data or management traffic is that some network information protocols such ...
Hi. When you have trunking configured between switches then native VLAN comes into play. 802.1q standard defines that there should be a native VLAN, when a 1q interface receives an untagged packet it will foward that packet to the native VLAN is has ...
Hi!Regarding the Administration and Monitoring tools for Cisco ASA Series, can they be monitored using CiscoWorks VMS? I havent found a patch for the VMS in order to support ASA5500 Series.I have heard that the ASA needs two separate administrative I...
