Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Does any one have any idea on the new features added or going to be available on the 8.5 release on the ASA. Would this release "finally" support VPN on multi security context mode. By the sounds of things looks like every other major vendor suppo...
HelloWhat does the command IP NAT Translation timeout * actually achieve?Does this command clear any IDLE nat entries in the nat dtable that have been idle for athe period specified by this comman or does it force remove nat entriesthat have been in ...
HiI have a 2821 router with DSP and digital modem module installed. with vwic and e1 nm module. Every thing works ok when I have my E1 lines configured as Voice lines but I cant hear any modem answerback tone from the digital modems when the E1 lin...
Hello I have a 2821 with nmc1e1pri and pvdm2dm configured as RAS. Contrller status is as follows Applique type is Channelized E1 - unbalanced No alarms detected. alarm-trigger is not set Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line. Mo...
lol,I wish some one in Cisco had a decent answer to this, most of us deploy VPN on our "firewalls" and need this in our environments. Cisco has been quit for a while on the upgrades, even for the patches and fixes for the almighty 8.4 (I call it Vist...
The strange thing is as I said before, I have tested the digital modemand also the NM in another site and they worked fine.I have thought perhaps thee was something else wrong with the chasis and I tested another chasis and yet no luck. I have no id...
