Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am wanting to upgrade my software in my Cisco ASA 5505 before putting it into the production network. I have called Cisco to get some information about this but cannot seem to get a clear "yes you can" or "no you can't" upgrade answer so I thought...
I am learning VoIP and am going to set one up at my house for experience training but need some advice since I am getting some conflicting information.I read that all you need for a basic VoIP setup, (not Unified,) is an IP Phone like the one I purch...
I have two home networks. For the sake of clarity, we'll call them Network A and B. Both consist of a Gateway Router, a 2621 router attached to this Gateway Router and a 2950 switch attached to the 2621 router. Neither network A or B are physicall...
I am trying to configure ASDM on my ASA 5505. I seem to be running into a road block. I get things configured correctly, IP Addressing, VLANs etc. I can ping my ASA device from the laptop command prompt with no problem.When I open the browswer and...
Does anyone know of any Cisco manuals or books on the 2511 Access Server. I have found documents online about this equipment but no real book or manual. I am looking for more of a command reference guide with some possible basic configuration setti...
Thanks.The first link, (SPA8800) is giving me a "Forbidden 403" message but the second link looks good. I will follow up on this. Thanks again.Also, if you know of any good Cisco text books on basic Voip, let me know as I am learning this on my own ...
Identical, yes with the exception that Network A has a second VLAN and the IP addresses are just a little different.As far as rotues outside of the 2621, yes. It is on fa0/0, (192.168.1.2 255.255.255.0) going to the gateway router whose address is 1...
This thought crossed my mind. I didn't have to do this with my other network (A.) I just set it to RIPv2 and used the same protocol on my 2621 that was connected to it and all was GTG. This DSL connected to the second network (B) does not have a R...
Thanks! This has been most helpful. I do have another question though. I am a registered user and have gone to the Cisco software download site but cannot seem to find any link to the ASDM software upgrades. I know they have to be there but I hav...
