Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I going to purchase 2 Firewall (FPR2110-NGFW-K9) and it will be deployed in ACTIVE/STANDBY mode.
DO i have to purchase a single (TAM)license for both device or 2 license (TAM) for both device for the Active/standby deployment scenario .
Best Re...
HI
I have configured PPTP in my router cisco 2901.
When I connect to to PPTP from my windows PC, I am getting internet connection. but I cant reach to the Remote networks connected to the firewall.
(Remote PC)======PPTPconnection ----Router-----Fire...
Hi
One of my clients asked me the below requirement.
"I wan to run CDP to all my Cisco Devices but under an ACL. The CDP will run only my LAN/WAN Devices which is allowed by IP/MAC address through an ACL.Only match IP addresses device will talk/commu...
HI,
Im not good at configuring N5k, i have configured one before. that worked fine. but right now im facing little problem.
I have configured the n5k Dell complent stroage(FC) and Dell Power edge R730 (CNA card[FCOE])
i have found that using showing...
HI
Im going to purchase the smartnet for the below product.
Product Smartnet Qnty
CTS-SX20-PHD12X-K9CON-ECDN-SX2PHD122CTS-QSC20-MICCON-ECDN-QSC20MIC2
As I have to collect the serial numbers of the h...
himy N3K shows this output. and my SIEM shows that the memory utilization is high 79%. Should i be worried or not ?SVR-SW-Secondary(config)# show system resourcesLoad average: 1 minute: 0.18 5 minutes: 0.30 15 minutes: 0.28Processes : 461 total, 1 ru...
Im having the same problem. Im using 1850i Mobility Express.when i put the guest ACL for GUEST WLAN, I cant connect to the GUEST SSID.
Here is my Screenshot of my rules:
Now All i want to block the guest network traffic to access my System.But whe...
HI.. Im having the same problem. I need 2 SSID(Different VLAN ) but cant configure it. Is there any document can you share with me ? I need to solve the issue ASAP.
I have not received the Smartnets yet. So cant open a TAC.
I have 8 ME AP.
I need to ...
Is there any solution of this login issue ? Im facing the same . changed my IP, resterted the VM but still having the same problem. My LAB setup is done in Vmware Workstation. is there any way around ?
